| BRAND | Gorman Rupp |
| Product | GRI-INTG3- 562 |
| Internal code | IMP5017224 |
| Weight | 0.45 |
| Custom code | 841370210010 |
| Technical specification | GRI-INTG3-562 Integrated Brushless DC Magnetic Drive Pumps INTG3 Series Specifications Voltage: 24V DC Lead Wires: 3-wire Power: max. 60W Current: max. 2.07A @ max. Flow Flow (H2O): max. 25.46l/min (6.73gpm) Head: max. 1.19bar / 12,13mWS (17.27psi / 39.83ft) Flow and pressure dependent on input voltage. Conn. Inlet / Outlet: 1/2" MHB Max. Fluid Temp: 95°C (203°F) Max Sys. Pressure: 5.17bar (75psi) Weight: 0.45kg (12.8oz / 362.9gr) Materials in contact with solution Body: PPS (Ryton®) Impeller: PPS (Ryton®) Pump Shaft: Ceramic Bearing Plate: PPS (Ryton®) Housing: PPS (Ryton®) Rotor Shell: PPS (Ryton®) Static O-Ring: EPDM Motor specifications Motor: Integrated, Brushless DC Supply Voltage: 9-24 VDC 60 Watts Inrush Current: None. Ramps up to running current. It is recommended that the customer provide circuit over current protection to the pump. 60 watt pump: 5 amp fast acting fuse is recommended. Electronics Max Power: 60 watts Remote Speed Control (Optional - Consult Factory) • Third Wire • 0-5 volts (Reference DC NEG). Speed is controlled by a nominal 0-5 volt DC signal. 3-Wire: Three wires are required when the pump speed is controlled by a nominal 0-5v DC signal. This is done through a control panel such as a computer or other control devices that is connected to the pump via the third wire. The 0-5v signal controls the speed of the pump, not the voltage supplied to the pump. O-Ring Material: EPDM = Ethylene Propylene Diene Monomer, FKM = Fluoroelastomer. Testing performed in a controlled laboratory environment. Actual performance may vary (+) or (-) 10% from the information shown. Do Not Run Pumps Dry. Pumps must be in a continuous flooded suction environment |
default.send_request_amp_Group2